Hi Adrian,
I apologize if I've misunderstood something, but what I think that you're saying is this:
1) You have a list of observed objects (is this the list that's in your above post?)
2) When you create a new ST4i Target List, you want to exclude these objects from the list.
3) Make a List without any of these objects.
If that's what you want, this might work:
Check out the Observed Status options by R-Clicking on the Status icon at the top of the column as shown here:
1) Create a list of your Observed Objects in ST4i (either enter them manually or find a list that has most of them & adjust it)
2) Using the Observed Status options, set all of these objects to 'Observed'
3) Make a log entry for these objects. Just a short entry sould be sufficient.
4) For any new Target List, 'Set Logged Objects to Observed' & Uncheck the 'Show Observed' in the Observed Status section.
5) This should Hide any objects in the list that you've already observed.
Greg can probably offer a more elegant solution.
Hope this helps,
Phil S.
EDIT: In reviewing your previous posts, it appears that the list you attached is indeed the objects you've already imaged. Also you said that you've created an ST4i Target List including these objects. If that's correct, then you've completed Step #1 of my suggested solution - probably the hardest part. Next mark all of these objects as 'Observed' & proceed to Step #3, etc.
I apologize if I've misunderstood something, but what I think that you're saying is this:
1) You have a list of observed objects (is this the list that's in your above post?)
2) When you create a new ST4i Target List, you want to exclude these objects from the list.
3) Make a List without any of these objects.
If that's what you want, this might work:
Check out the Observed Status options by R-Clicking on the Status icon at the top of the column as shown here:
1) Create a list of your Observed Objects in ST4i (either enter them manually or find a list that has most of them & adjust it)
2) Using the Observed Status options, set all of these objects to 'Observed'
3) Make a log entry for these objects. Just a short entry sould be sufficient.
4) For any new Target List, 'Set Logged Objects to Observed' & Uncheck the 'Show Observed' in the Observed Status section.
5) This should Hide any objects in the list that you've already observed.
Greg can probably offer a more elegant solution.
Hope this helps,
Phil S.
EDIT: In reviewing your previous posts, it appears that the list you attached is indeed the objects you've already imaged. Also you said that you've created an ST4i Target List including these objects. If that's correct, then you've completed Step #1 of my suggested solution - probably the hardest part. Next mark all of these objects as 'Observed' & proceed to Step #3, etc.