Getting exposure time into project

[theskyhound]

Sorry, I wasn't clear. On the Imaging Systems dialog there is a button labeled Exposure Times. When you click on this button a dialog opens. This dialog allows you to tell SkyTools what the allowed exposure times are. There are two ways to do this: by selecting a range of allowed exposure times (e.g 1-5 minutes), or by entering a list of allowed exposure times (e.g. 60, 90, 120, 300). The imaging system that I received only allows for a single exposure time: 60 seconds (which is unusual).

In order to try to understand this problem, I need to know if it has always been set to 60 seconds only, or if you had more allowed exposure times at the time when the problems you reported earlier occurred. .