2020-07-19, 10:14 PM
Please do not re-install! That seldom changes anything.
I doubt very much if there is a problem with the software. I think maybe you are just misunderstanding something or have an expecation for the tool that is out of line with what it does.
I can't say much of anything of use because I don't have the critical data about your telescopes, eyepieces, location, weather settings etc.
I just tested things for me and it worked just as expected. Please try to do what I did, and then send me screen captures of the Real Time window and the Nightly Planner. Here is what to do:
1. Wait until it is dark (or play with the time, although I hate to see people do that because it can wreak havok with your computer).
2. Start Real Time and make sure it is in Best Now Mode
3. Select your observing list
4. Right-click on the red check mark at the top of the check mark column and select Clear All
5. Right-click again and select check Displayed
6. Take a screen capture of the entire Real Time window
7. Open the Nightly Planner
8. Make sure it is set for the same date and select the same list. Turn off all filters.
9. Highlight the object that you think should have been displayed on Real Time by selecting it
10. Send me a screen capture of the entire Nightly Planner Window
I doubt very much if there is a problem with the software. I think maybe you are just misunderstanding something or have an expecation for the tool that is out of line with what it does.
I can't say much of anything of use because I don't have the critical data about your telescopes, eyepieces, location, weather settings etc.
I just tested things for me and it worked just as expected. Please try to do what I did, and then send me screen captures of the Real Time window and the Nightly Planner. Here is what to do:
1. Wait until it is dark (or play with the time, although I hate to see people do that because it can wreak havok with your computer).
2. Start Real Time and make sure it is in Best Now Mode
3. Select your observing list
4. Right-click on the red check mark at the top of the check mark column and select Clear All
5. Right-click again and select check Displayed
6. Take a screen capture of the entire Real Time window
7. Open the Nightly Planner
8. Make sure it is set for the same date and select the same list. Turn off all filters.
9. Highlight the object that you think should have been displayed on Real Time by selecting it
10. Send me a screen capture of the entire Nightly Planner Window
Clear skies,
Greg
Head Dude at Skyhound
Greg
Head Dude at Skyhound